SNES Advanced DIP42 2MB

In stock
SNES Advanced DIP42 2MB
  • Buy 10 for $3.75 each and save 6%
  • Buy 50 for $3.50 each and save 13%
  • Buy 250 for $3.25 each and save 19%

2MB SNES Board with save!

SNES Advanced DIP42 2MB

The SNES Advanced DIP42 2MB is a homebrew or reproduction board that supports LoROM and HiROM games up to 2MB (16 Megabit) with a 42 Pin EPROM with support WRAM with a battery.

Component List

ROM - 27C400/27C800/27C160 or compatible. Please note this board is NOT compatible with the 27C322 (Not Carried)

6264 (Not Carried) (62128/62256 possible with rewiring.)

Lockout Chip - SuperCIC Key (12F629 programmed with Super CIC Key) (HERE)

Address Decoder Chip 74LS139 (HERE)

C1,C4 - 22uf 16 V Capacitor (HERE)

C2,C3 - 0.1uf 50V Capacitor (HERE)

D1,D2 - 200 MA Schottky Diode (HERE)

R1 - 10K Ohm Resistor (HERE)

R2 - 1K Ohm Resistor (COMING SOON)


Battery - CR2032 Battery with tabs (Not Carried)

R3,R4, D3, and D4 - Are optional components for adding LEDs. Please note that no testing of this has been done and you are completely on your own to figure this out.

I have also added a new footprint for a SuperCIC programmed to a 10F322. Please not this has not yet been tested and is not guaranteed.


Build instructions/tutorials aren't available at this time. If you are uncomfortable or new to building your own cartridges please wait for tutorials to become available.

Write Your Own Review
You're reviewing:SNES Advanced DIP42 2MB